How To Install Fence Panels At Odd Angles

I don't encounter any need for a 2nd post. Here's how I would practise information technology. Incidentally, buy some 3" deck screws for this if you don't take any. You will WANT to use screws here, even if you've been nailing

1. Set the post square with the bottom part of the fence in your diagram, but extend the 2x4s all the way beyond to the edge of the 4x4
2. Take a miter saw and gear up it at 45 degrees. Cut i terminate of your next boards vertically so that the saw goes through the corner of the board (right manus cut with the board standing upward)
3. Dig the hole for the next post (along the angle). Put the 4x4 in but do Not set concrete yet. This hole may be slightly further apart than the previous ones, and so take that into business relationship. You might want to dry out fit the 2x4s first just to brand sure (re-digging holes is a pain)
4. Have someone hold the 2x4 you just cutting on the end by the 4x4 you just added. Screw the askew end into the 2x4 you ran across the previous 4x4. Be careful not to get too shut to the border of the askew board or it may split.
5. With your compatriot nonetheless holding the 2x4, get the 4x4 level and then adhere the 2x4 to the 4x4 (leaving room for the next set of boards). Repeat for however many stringers you're running
6. Pour concrete for the new 4x4 (your stringers volition hold it in place) and now you're fix to run your 45 caste side from there.

Congratulations! Yous've but made a 135 caste turn

Now, if y'all're scared about the 2x4 splitting (or you got the screw as well close to the edge), what you lot can exercise is accept a spare slice of 2x4, cut some pieces (same number as stringers) the same size every bit the 4x4 (most 3.five") and bevel it 45 degrees the other way (left mitt cut) earlier you showtime step #four. Spiral these onto the 4x4 and then you can sink 2 additional screws perpendicular to the board you're placing, though these additional pieces and into the 4x4 itself. This will guarantee you lot a strong corner, merely it tin can be overkill. I'll leave information technology to you if you want to do this extra stride.

Source: https://diy.stackexchange.com/questions/114889/how-to-do-a-45-degree-corner-on-a-privacy-fence

Posted by: gonzalezarager.blogspot.com

Share this post